日本語
Français
Português
Việt Nam
Türkçe
Eesti
Bai Miaowen
hrvatski
українська
Nederlands
বাংলা
The Main Function of Garbage Crane
Garbage crane is one of the key equipment of garbage incineration power plant. Its main function is to transfer, stack, weigh and feed the garbage in the garbage storage pit. Garbage crane electrical equipment provides the core equipment to drive and control the normal operation of garbage crane, and the normal operation of garbage crane is related to the normal and stable operation of garbage incineration power plant. This paper will deeply analyze the operation precautions and common fault analysis in the operation of garbage crane for reference by relevant practitioners.
Feeding: When there is insufficient waste at the feed port of the incinerator, the waste crane grabs the fermented waste in the waste pond and runs it above the feed port to feed the hopper of the waste incinerator.
Handling: The garbage near the discharge door is transported to other places in the garbage tank to avoid the congestion of the discharge door, and the amount of garbage in the tank is adjusted so that it is stored for not less than 7 days.
Agitation: Due to the high water content of domestic domestic waste and the low calorific value of combustion, the waste needs to stay in the garbage pond for a certain time, and the water content is reduced and the calorific value is increased through natural drainage and fermentation. The mixing of old and new refuse can shorten the fermentation time. In addition, due to the complex composition of domestic waste, the composition content changes greatly, in order to avoid excessive fluctuations in the nature of the furnace waste, to ensure the stable combustion of the furnace waste, it is also necessary to stir and mix the waste in the pool.
Pick up: Remove the objects that accidentally enter the garbage pool but are not suitable for incineration.
Weighing: In order to calculate the actual amount of waste incinerated, the waste put into the feed port of the incinerator is weighed and measured before it is put into the feed port.
